Re: Poulan Pro Model 135 (Gas Edger)

gecko wrote:
> On Wed, 14 May 2008 19:18:13 -0400, Art <Artemis@[EMAIL PROTECTED]
>
> wrote:
> 
> 
>> Works for me. If you click on the + next to 'Illustrated Parts Lists"
it 
>> should expand and show 2 entries below it. Click on "Carburetors...".
>> That should bring up a new window with the carb breakdowns. One version

>> with a primer and one without. The part numbers are at the bottom.
Click 
>> on a part reference number and it should highlight in the parts
listing.
>>
>> It's not that complicated.
> 
> 
> Excuse my stupidity please.
> 
> When I click on 'Carburetors'. I get only one page - with a schematic
> at top and a parts ordering list of 16 parts below.  If I click on a
> part,  I get a window to add purchase of that part to my cart.  I see
> only one schematic.  I see no primer.
> 
> I agree - it's not complicated.
> 
> Thanks
> 
> -GECKO

In an earlier post you said your edger didn't have a primer so I'm not 
sure why you are looking for one. The picture shows one but then does 
not list a part number, probably because your model doesn't use one. 
It's just a generic picture that is used in lots of parts lists.

Parts for the carb itself should be available locally from any decent 
power equipment shop. Just tell them you need parts for a Walbro carb 
and give them the number off the carb body. Should either be WT-242 or 
WT-308 (according to the Poulan parts list.) Don't mention that it is 
for a Poulan and they should be glad to help you.

Or if you will tell me exactly what parts you need, I'll see what I can 
do as far as getting you the correct part numbers.

-- 
Art